Skip to content

Super Glue PIPETTE

EAN: 4026700409741Article No.: 35732
Ultra-fast and extremely strong liquid super glue in a solid, safe-standing pipette container with Direct-Stop-Technology and a thin dosing nozzle. Ensures controlled, non-drip glueing with utmost precision. Flows into smallest corners and joints. Dishwasher proof and water resistant.
  • Ultra fast and extremely strong
  • Safe-standing container with Direct-Stop-Technology and thin dosing nozzle
  • Easy and precise to apply
  • Does not drip
  • Dishwasher proof and water resistant

Properties

  • Ultra fast and extremely strong
  • Safe-standing container with Direct-Stop-Technology and thin dosing nozzle
  • Easy and precise to apply
  • Does not drip
  • Dishwasher proof and water resistant

Application

Suitable for:

Ideal for small-area bonds. Glues almost all solid and flexible materials like many plastics (such as rigid PVC, ABS, PS, Plexiglas®, polycarbonate (Makrolon®), and phenolic resins (Bakelite®)), porcelain, ceramics, leather, metal, wood, cork, felt, cloth (check suitability first), and rubber. Only partly suitable for glass (over a certain period of time the bond becomes brittle, causing it to weaken).

Not suitable for:

Not suitable for PE, PP, silicone resins, PTFE, Styrofoam®, fabrics and leather clothing.

Handling

Before use

Working conditions

Do not use at temperatures below +10 °C. The glue responds best to an air humidity level of 50-70 %.

Surface requirements

Surfaces to be glued must be clean, dry, and free of dust and grease, and must fit exactly.

Preliminary surface treatment

Any dust, oil, grease, wax or separating agent should be thoroughly removed from the surfaces to be stuck together. The best way to achieve this is to rub the parts a number of times with appropriate solvents, such as acetone (if suitable for the material – check first!). For metals and metal alloys it is usually sufficient to roughen the surface using emery paper or by grinding or brushing.

During use

Directions For Use

1. To pierce the membrane, turn the whole cap clockwise firmly onto the container. Do not press while piercing. 2. Unscrew the top cap to reveal applicator. Apply a thin layer of adhesive to one side by exerting sufficient pressure on the middle of the container’s body (too much glue slows down the curing process significantly). Press parts together immediately. After use: Clean nozzle with a dry tissue and replace cap.

Advice

When glueing at low humidity, curing time can be shortened by briefly breathing onto one of the parts to be assembled. The best glueing results are reached at room temperature.

Points of attention

Contains cyanoacrylate. Bonds skin and eyelids together in seconds. If product comes into contact with the eyes, rinse immediately with plenty of water and seek medical advice. In case of contact with skin, glue can be dissolved by soaking in warm soapy water. Then apply a skin cream. May cause respiratory irritation. Avoid breathing vapours. Keep out of the reach of children.

After use

Stains/residue

Wipe off excess glue immediately with a dry cloth. After curing, glue residue is very difficult to remove. Acetone will dissolve glue but very slowly (check suitability first).

Storage conditions

Store in a dry, cool, frost-free place. Storage below +5 °C (in refrigerator) ensures maximum shelf life.

Documents

Similar products