Suitable for fast, strong and invisible repair of many materials, such as pottery, porcelain, glass, leather, wood, stone, metal, ceramics. Both with themselves and in combination.

Not suitable for Polyethylene (PE), polypropylene (PP), PTFE and silicone rubber.

Recomended application at temperatures between +10 °C and +35 °C. Product cures by mixing the resin and hardener.

The surface must be dry, clean and free of dust and grease.

Degrease parts to be bonded with denatured alcohol. Roughen smooth surfaces (sandpaper).

Mix the components by means of the supplied mixing bowl and spatula.

1:1

1 ml = approx 10cm² at a film thickness of 1 mm

Press out an equal amount of both components onto the enclosed mixing tray. Mix these two equal parts well with spatula until a mixture is obtained with a homogeneous colour. Put parts together to fit exactly without pressure. Process time approximately 5 minutes at room temperature. The functional strength is reached after 20 min, final bonding strength after 12 h (both at room temperature).

Some types of synthetics can not be joined such as polyethylene and polypropylene. Use a piece of adhesive tape in order to keep the parts in place while the adhesive is curing.

After use close well (note: always place back the cap in the same way, due to the bonding of the cap to the double syringe). For optimum performance it is important to create a larger amount of adhesive and mix it very well. Curing time depends on the temperature. Adhesive does not cure below +5°C.

Remove wet stains immediately with warm water and soap. Cured adhesive residue can only be removed mechanically.

Store in tightly closed packaging in a dry, cool and frost-free place.