Skip to content

Epoxy Ultra Strong

EAN: 4026700456707Article No.: 63251
Universal strong dual-component epoxy adhesive for repairing metal, pottery, porcelain, glass, pearls, precious stones and various synthetics. Temperature resistant, water resistant, chemical resistant and paintable.
  • Super-strong (up to 170 kg/cm²)
  • Resistant to temperatures between -40 °C and +100 °C
  • Filling
  • Water resistant
  • Chemical resistant
  • Paintable

Properties

  • Super-strong (up to 170 kg/cm²)
  • Resistant to temperatures between -40 °C and +100 °C
  • Filling
  • Water resistant
  • Chemical resistant
  • Paintable

Application

Suitable for:

Suitable for repairs to metal, ceramics, porcelain, crystal, glass, pearls, precious stones and various synthetics (polyester, bakelite, formica, rigid polystyrene and acrylic glass (Perspex®).

Not suitable for:

Not suitable for Polyethylene (PE), polypropylene (PP), PTFE and silicone rubber.

Handling

Before use

Working conditions

Only apply at temperatures between +10 °C and +35 °C. Product cures by mixing the resin and the hardener.

Surface requirements

The surface must be dry, clean and free of dust and grease.

Preliminary surface treatment

Degrease parts to be bonded with methylated spirit. Roughen smooth surfaces (sandpaper).

Tools

Mix the components by means of the supplied mixing bowl and spatula.

Mixture ratio

1:1

Coverage

1 ml = approx 10 cm² at a film thickness of 1 mm

During use

Directions For Use

Press out an equal amount of both components onto the enclosed mixing tray. Mix these two equal parts well with a spatula until a mixture is obtained with a homogeneous colour. Apply the mixture, which at room temperature (+20 °C) remains toolable for about 1.5 hours, as a thin layer on one of the two materials. Join the materials and keep them in place for 7 hours. Be careful not to move the parts before the adhesive has cured. Resin and hardener must not come into contact with each other unless for usage.

Advice

Some types of synthetics can not be joined such as polyethylene and polypropylene. Use a piece of adhesive tape in order to keep the parts in place while the adhesive is curing.

Points of attention

Close well after use. For optimum performance it is important to create a larger amount of adhesive and mix it very well. Curing time depends on the temperature. Adhesive does not cure below +5 °C.

After use

Stains/residue

Remove wet stains immediately with warm water and soap. Cured adhesive residue can only be removed mechanically.

Storage conditions

Store in tightly closed packaging in a dry, cool and frost-free place.

Documents

Similar products